Filter Holders and Hardware
Filter Holders and Hardware
Cole-Parmer™ Advantec 301900 Pressure Filtration Holder
Process samples from an in-line system or pressure vessel with this stainless steel holder. Cole-Parmer™ Advantec 301900 Pressure Filtration Holders maximize flow rates by applying positive pressure to the fluid over a broad membrane surface.
DWK Life Sciences Kimble™ Kontes™ Filtration Assemblies: Flasks With Side Arm, No. 2 Hose connection
Borosilicate glass flask with side arm, No. 2 hose connection.
DWK Life Sciences Kimble™ Kontes™ Ultra-Ware™ Microfiltration Assembly with Fritted Glass Support (47mm)
Used for general filtration and is designed to handle up to 500mL of sample liquids for the analysis of particulate or microbiological contamination
Pyrex™ Funnel for Filtration System
For use with Pyrex™ Borosilicate Glass Filtration System.
DWK Life Sciences Kimble™ Kontes™ Ultra-Ware™ Microfiltration Assembly with Fritted Glass Support and Ground Joint (90mm)
Designed for large volume filtration analysis of corrosive liquids or samples with high particulate loads that would tend to clog a 47 mm diameter filter
Advantec Stainless Steel Pressure Filtration Holder
Stainless Steel Pressure Filtration Holder made of stainless steel type 304 or 316 minimizes resistance and maximizes flow rate.
DWK Life Sciences Kimble™ Ultra-Ware™ Glass Support Base
The Kimble™ Ultra-Ware™ Glass Support Base is suitable for use with Kimble™ Ultra-Ware™ Microfiltration Assemblies.
DWK Life Sciences Kimble™ Kontes™ Ultra-Ware™ Microfiltration Assembly with Stainless Steel Support (90mm)
Designed for large sample volumes or samples with high particulate loads that would tend to clog a 47mm diameter filter
DWK Life Sciences Kimble™ Ultra-Ware™ Fritted Glass Support Base
The Kimble™ Ultra-Ware™ Fritted Glass Support Base is supplied with a 40/35 joint and glass frit. It is suitable for use with the Kimble™ Ultra-Ware™ 90 mm Microfiltration Assembly.
Advantec Stainless Steel Pressure Filtration Holder with Reservoir
Stainless Steel Pressure Filtration Holder with Reservoir made of stainless steel type 304 or 316 minimizes resistance and maximizes flow rate.
Merck Accessories for Glass Microanalysis Filter Holders
Accessories for filter holders for sample preparation.
R&L Enterprises™ Nickel Plated Brass Vacuum Pump
Evacuates a 1L system to 200mbar in 40 seconds (water supply at 170kPa, consumption 3.5L). R&L Enterprises™ Nickel Plated Brass Vacuum Pumps do not require a tail pipe.
DWK Life Sciences DURAN™ Filter Disc Sintered Glass, Porosity 3, edge not fused
A prerequisite for successful work with glass filters is the selection of the right porosity. It is important to select a filter whose largest pore size is slightly below the grain size of the smallest particles still to be separated.
Deutsch Neumann™ Rubber Spacers for Filtering Sets (GUKO)
Excellent for general laboratory use. Deutsch Neumann™ Rubber Spacers for Filtering Sets (GUKO) are manufactured from natural rubber.